32
02
Air lter (Fig. T)
This product is supplied with an air lter (23a). Inspect the air lter (23a) regularly.
Replace it with a new one if necessary.
1. The air lter cover (23b) is located at the bottom of appliance. Disengage the three
latches (23c) and remove the air lter cover (23b) (Fig. T, step 1).
2. Remove the air lter (23a) (Fig. T, step 2) and tap it on a solid surface to remove
dust. Use compressed air (max. 3 bar) to remove stubborn dust.
3. Clean the air vents (23) with a cloth and brush.
4. Ret the air lter (23a) and air lter cover (23b). Ensure the three latches (23c)
snap back into position.
Maintenance
Before and after each use, check the product and accessories (or attachments) for
wear and damage. If required, exchange them for new ones as described in this
instruction manual. Observe the technical requirements.
01
Power cord
If the power cord is damaged, it must be replaced by the manufacturer, its service
agent in order to avoid a safety hazard.
WARNING! Do not use the product with a defective or a loose power
cord!
02
UK PLUG (ONLY FOR UK MARKET)
If you need to replace the tted plug, then follow the instructions below.
IMPORTANT: The wires in the mains lead are coloured in accordance with the following
code:
Blue – Neutral
Brown – Live
As the colours of the wire in the mains lead of this product may not correspond with
the coloured marking identifying the terminals in your plug, proceed as follows. The
wire, which is coloured blue, must be connected to the terminal, which is marked with
N or coloured black. The wire, which is coloured brown, must be connected to the
terminal, which is marked L or coloured red.
MNL_Erbauer_GB_EPS800_800W paint sprayer_V1_201020.indd 32 10/20/20 5:03 PM
To Next Page
Loading...
