Erbauer ERB337TCB - Page 17

INSTALLATION OF THE DIAMOND DISC (B-E)
- Unplug the tile cutter from the mains supply.
- Remove the cover (45° vertical fence) of the water tank.
- Insert the inner flange, the diamond disc and the outer flange on the spindle (B)
then tighten the bolt clockwise with the two spanners provided (C).
- Insert the blade lower guard into the notches then tighten the screw (D-E).
- Put the cover back into position.
INSTALLATION OF THE PROTECTIVE GUARD (F)
- Unplug the tile cutter from the mains supply.
- Place the guard onto the metal bracket and fix in place using the screw and washer
(F). Push the lock knob (for protective guard) over the nut.
- Cover the diamond disc with the protective guard.
- Ensure that protective guard can move freely and that it cannot touch the disc.
- Do not over tighten the protective guard when fixing it. The guard should be free
to rise and fall as the workpiece is pushed towards the disc.
INSTALLATION OF THE PARALLEL GUIDE (G - K)
- Unplug the tile cutter from the mains supply.
- Insert spring, clamp, washer and lock knob (for parallel guide) to the bolt of parallel
guide (G), then tighten the lock knob (H).
- Put the parallel guide onto the working table and fix it using the lock knob (I).
- Mitre cutting can be performed by using the mitre cutting guide. The angle can be
adjusted from 0° to 45° by unscrewing the lock knob (for mitre cutting guide) (J).
- To perform 22.5° or 45° bevel cutting, raise one side of the cover (45° vertical
fence), lever out the support and secure the tabs into the places in the deck before
working (K).
EXTENSION OF THE WORKING TABLE (L)
- Unplug the tile cutter from the mains supply.
- Pull out the table extension to the required length and then secure it by the lock
knob (for extension table) shown in (L).
FILLING THE WATER TANK (M)
Before cutting, the tank must be filled with water:
- Unplug the tile cutter from the mains supply.
- Remove the metal cover (45° vertical fence) from the working table.
- Insert the water reservoir plug into the drain opening.
- Fill the tank with water in order to just cover the disc edge (ensure that no more
than ¼ of the disc is submerged in water).
17
EN