WARNING! Always switch the product off, disconnect
the product from the power supply and let the product
cool down before performing inspection, maintenance
and cleaning work!
Care & maintenance
Note: Do not use chemical, alkaline, abrasive or other
aggressive detergents or disinfectants to clean this
product as they might be harmful to its surfaces.
- Keep the product clean. Remove debris from it after each use and before storage.
- Regular and proper cleaning will help ensure safe use and prolong the life of the
product.
- Inspect the product before each use for worn and damaged parts. Do not operate
it if you find broken and worn parts
GENERAL CLEANING
After use, clean all excess dust from the table and the area around the
table. Frequently clean the machine using a soft brush or vacuum cleaner.
MAINTENANCE
Ensure that appliance is disconnected from power supply before installation,
cleaning and maintenance operations.
Apart from diamond discs there are no other user serviceable parts inside this tile
cutter. Refer to qualified service personnel if internal maintenance is required. Any
worn or damaged parts should be replaced immediately by qualified personnel.
Keep discs in good condition. Poor condition or worn discs can increase the noise
level emitted. Do not allow dust to accumulate inside, or on the product.
If the supply cable is damaged, it should be replaced by the same type of cable
as the one provided and recommended by the manufacturer (H05 VV-F 3G0.75
mm²). The supply cord of the tool and any extension cord used should be checked
frequently for damage. If damaged, have the cordset replaced by an authorised
service facility. Replace the extension cord if necessary.
THE GOLDEN RULES FOR CLEANING
21
EN
To Next Page
Loading...
