Use
INTENDED USE
This tile cutter shall be used only to cut tiles to a required size or shape. It shall
not be used to cut inflammable, explosive or toxic materials. Other uses for the
machine will lead to the damage of the machine and a series of dangers to the
operator. Only identical accessories as the ones provided with the tile cutter are
authorised. Never use the appliance in the rain or other wet conditions.
GENERAL OPERATION
Put the tile cutter on a clean, stable and flat surface.
MAKING A STRAIGHT CUT
Adjust the parallel guide to the desired width. Use the lock knob (for parallel guide)
to loosen or adjust the guide. Position the tile firmly against the parallel guide and
move it through the blade in a smooth action. Hold the edges of the tile and press
down firmly to prevent the tile lifting during the cut.
MAKING A MITRE OR DIAGONAL CUT
Follow the same procedure for a straight cut but use the mitre cutting guide in
conjunction with the parallel guide. The mitre cutting guide simply clips onto the
parallel guide. Make sure that the tile is held firmly in the guide before making the
cut.
CUTTING AN ANGLE OR BEVEL
Use the 45° vertical fence if you wish to cut an angle or bevel on the tile edge. Lift
the 45° vertical fence and secure the plastic tabs in the places on the deck. Then
make the cut as before.
Internal or external bevel cuts can be made by turning the tile face up or down
(internal - eg.wall corner; external - eg. window reveal).
AFTER USE
- Switch the product off, disconnect it from the power supply and let it cool down.
- Check, clean and store the product as described below.
20
EN
To Next Page
Loading...
