WARNING! Troubleshooting could lead to an increased
risk to the operator due to the fact that safety guards /
covers may have to be removed.
It is therefore particularly important that all the measures
necessary for safe working are taken.
TROUBLESHOOTING
Suspected malfunctions are often due to causes that the users can fix themselves.
Therefore check the product using this section. In most cases the problem can be
solved quickly.
Fault
Motor not running
Possible causes Possible solutions
No main voltage Check cable, plug socket and
fuse
Motor runs, cutting disc remains
still when subject to load
Flange nut loose Check the flange is seated
correctly and tighten if necessary
Cutting disc runs irregularly/
vibrates
Cutting disc warped Replace the cutting disc
Cutting disc is discoloured Insufficient cooling water Fill the product with water
Cutting disc fitted incorrectly Fit the cutting disc correctly
Lateral friction caused by cut
runout
Guide workpiece through cutting
disc more slowly
24
EN
To Next Page
Loading...
