POWER CORD
If the power cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified person in order to a safety hazard.
PLUG REPLACEMENT
If you need to replace the fitted plug then follow the instructions below.
Important
The wires in the mains lead are coloured in accordance with the following code:
Green & yellow - Earth
Blue - Neutral
Brown - Live
As the colours of the wires in the mains lead of this appliance may not correspond
with the coloured markings identifying the terminals in your plug, proceed as follows.
The wire which is coloured green & yellow must be connected to the terminal which
is marked with E or .
The wire which is coloured blue must be connected to the terminal which is marked
with N. The wire, which is coloured brown, must be connected to the terminal, which
is marked with the letter L.
Note: If a moulded plug is fitted and has to be removed
take great care in disposing of the plug and severed
cable, it must be destroyed to prevent engaging into a
socket. If the supply cord is damaged it must be replaced
by a service agent or a similarly qualified person in
order to avoid hazard.
WARNING! Never connect live or neutral wires to the
earth terminal of the plug. Only fit an approved 5 Amp
BS1363/A plug and the correct rated fuse.
Green & Yellow E(Earth)
Blue
(neutral)
N
5amp fuse
approved to
BS1362
Brown
(live)
L
Cable grip
Outer sleeve
5amp
22
EN
To Next Page
Loading...
