WARNING! This machine must be supplied through
a residual current device (RCD).
- Plug the mains cable into the mains supply.
- Press the green switch marked I.
- The machine will now start. Always allow the disc to
reach full speed before performing any cutting operations.
- To switch off the machine, push the red switch marked
O. The tile cutter will now stop.
WARNING! Before switching the tile cutter on, make
sure that you have read and understood all of the safety
instructions. Make sure also that the machine has been
correctly assembled and adjusted. Make sure that the
mains is disconnected from the supply when the tile
cutter is not being used or adjustments are being made.
- When you have finished cutting, remove the plug inside the tank to drain
the water (M).
CONNECTION TO THE ELECTRICAL SUPPLY
Before switching on, make sure that the voltage of the mains supply is the same
as indicated on the rating plate. This product is designed to operate on 220-240V~
50Hz. Connecting it to any other power source may cause damage.
This appliance must be earthed. If in doubt, please consult a qualified electrician.
The mains supply shall be fed via a 10A fuse min.
This machine must be supplied through a residual current device (RCD).
WARNING! During use the water level must never
drop below the MIN marking.
WARNING! Do not add chemicals or detergents to the
water.
18
EN
To Next Page
Loading...
