21. Warning.
> The use of any accessory or attachment other than one recommended in this
instruction manual may present a risk of personal injury.
22. Have your tool repaired by qualified person.
> This electrical tool complies with the relevant safety rules. Repairs should only
be carried out by qualified persons using original spare parts, otherwise this
may result in considerable danger to the user.
ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR TILE CUTTER
- Do not use diamond discs which are damaged or deformed.
- Replace table insert when worn.
- Use only diamond discs recommended by the manufacturer.
- Take care that the selection of the diamond discs is suitable for the material to
be cut.
- Wear suitable personal protective equipment when necessary, this should include
hearing protection to reduce the risk of induced hearing loss, respiratory protection
to reduce the risk of inhalation of harmful dust, gloves when handling diamond
discs and rough material.
- Never use blades on this machine.
- Use only diamond discs for which the maximum possible speed is not less than
the maximum spindle speed of the tool and the material to be cut.
- Faults in the machine, including guards or diamond discs, should be reported as
soon as they are discovered. Never use the machine without the guard in position.
- Maximum size of working piece should be 1m².
- This tile cutter should be used with limitations on ambient conditions (between
15°C and 30°C).
- The machine must be supplied through a residual current device (RCD) having
a rated residual operating current not exceeding 30 mA.
FOR TOOLS INTENDED TO BE CONNECTED TO A WATER SUPPLY:
- For tools provided with a PRCD: Never use the tool without the PRCD delivered
with the tool,
- For tools provided with an isolating transformer: Never use the tool without the
transformer delivered with the tool or of the type as specified in the instructions,
- Replacement of the plug or the supply cord shall always be carried out
by manufacturer of that tool or their service organisation.
- Keep water clear of the electrical parts of the tool and away from persons in the
working area.
09
EN
To Next Page
Loading...
