Cleaning and maintenance
09/2011 1002410-04 Operating instructions – 37
Component Interval Activity See page
After each
tanning session
When necessary
50 h
5 Acrylic glass panel X Cleaning and disinfection 35
14 Control panel X Cleaning and disinfection 35
15 Adjustable air nozzles X Cleaning and disinfection 35
17 Sensor and base station X Cleaning and disinfection 35, 48
Handle X Cleaning and disinfection 35
Protective goggles X Cleaning and disinfection 35
MP3 cable X Cleaning and disinfection 35
6 Condensation tank X Empty 57
8 Body cooling air nozzles, foot end X Clean 35
9, 11, 16 Surfaces X Clean 35
12 Nozzles AQUA FRESH AROMA system X Clean 35
13 Body cooling air nozzles X Clean 35
1 Filter X Remove and clean filter 55
2-4 Filter X Remove and clean filter 57
7 Filter X Remove and clean filter 54
10 Filter X Remove and clean filter 55
NOTE:
Cleaning must be confirmed after each tanning session by
pressing the START/STOP button (when the warm-down
time for the main fan has finished).
5.5 Maintenance
Maintenance and care play a major role in deciding whether the device meets
the requirements placed on it in a satisfactory manner. Compliance with the
specified maintenance intervals and the careful conducting of the mainte-
nance and care work are therefore absolutely necessary.
The current operating hours of maintenance parts can be called up in service
mode (see 'Voreinstellungen/Presettings', order no. 1008953-..).
We point out that the device must be subjected to regular inspections by our
customer service or an approved specialized company every 12 months (from
commissioning) to maintain its proper condition!
Inspections and maintenance work that has been carried out must be entered
in the equipment, operating and maintenance booklet (order no. 1010363-..).
To Next Page
Loading...
Need help?
General
