Front Panel Control
Program Specific Information
Transport Stream ID A new ID can be assigned to the Transport Stream.
PAT-PMT On, Off
PAT-PMT Parameters
100 ms, 400 ms, 500 ms. Specifies how often (in ms) the PMT shall
be transmitted.
DVB, ATSC, DVB & ATSC
CAT On, Off
TSTD On, Off
Service Information
Original Network ID
NIT On, Off
NIT Parameters
Set Network Name
Set network ID.
Off, IEC 62216, NorDig v1, DTG Default
- SIRG
On, Off. If PSI/SI Level is set to On (PAT/PMT/SDT/CAT/NIT) make
sure the Send extended NIT (SIRG) is On so that the Carrier ID is
sent.
True, False
SDT On, Off
IP Bit Rate
Specifies the Bit Rate of the IP output and includes the overhead
added by IP encapsulation. Read only parameter.
TS Packets per IP Packet
1 - 7. Specifies how many Transport Stream packets to encapsulate
in one IP packet.
IP Encapsulation
UDP, RTP, RTP FEC Column, RTP FEC Column and Row.
Specifies what higher layer to encapsulate in IP packets. UDP and
RTP is self explanatory and means that the Transport Stream is first
encapsulated in UDP or RTP packets, then an IP header is added.
If RTP FEC column or RTP FEC Columns and Row is selected one
(Column) or two (Column and Row) RTP streams are output in
addition to the RTP streams that carry the Transport Stream.
FEC Rows The number of rows used in FEC encoding.
FEC Columns The number of columns used in FEC encoding..
FEC Alignment
Block Aligned, Non Block Aligned. The aligned method used for Pro
MPEG FEC..
IP Output Configuration
Destination 1 Selects Destination 1.
Destination IP Address
The destination IP address to use in the IP packet header of the IP
packets that carry the Transport Stream
To Next Page
Loading...