Ericsson AVP 3000 Series - Page 144

Front Panel Control
4-28
EN/LZT 790 0023/1 R16A
Video Monitor Usage Time The cumulative time the TND was switched on.
Video Monitor Brightness 0-7. Sets the brightness of the TND (CMU) display.
Key Lock Time
The time in seconds after which the keyboard gets locked to prevent
accidental key presses.
Default Screen on Key Lock
When set to on the menu will return to default screen. Set to off to
remain on current screen after timeout lock.
Default Screen Type Classic – enables the scrolling status information
Alternative disables the scrolling status
Carrier ID Setup Carrier ID information for use in NIT and RF outputs.
Operator
Phone Number
Longitude
Latitude
User Information
NIT Descriptor Ta
g
TSTD Setup
Usual Station Code
SNG HQ
SNG Provider
Remote Server Logging
Remote Server IP Address
The IP address to which system messages selected for remote
logging are sent. A value of 0.0.0.0 disables all remote logging.
Alarm Logging
Off, On. When set to On, all alarm log messages are copied to the
remote server.
ESAM Logging
Off, On. When set to On, all ESAM log messages are copied to the
remote server.
SCTE
-35 Logging
Off, On. When set to On, all SCTE-35 log messages are copied to the
remote server.
User Configuration Logging
Off, On. When set to On, all user configuration changes are sent to
the remove server.
Reflex Parameters
PCR Port
The UDP port on the current unit to which PCR Exchange Messages
are sent.
Command port
The UDP port on the current unit to which Set Rate Messages are
sent.
Status Port
The UDP port on the multiplexer to which Status Messages are sent
from the current unit.
PCR Exchange Timeout Port
The maximum time between PCR Exchange Messages. If exceeded,
PCR Exchange Timeout Alarm is triggered.