Web GUI Control
5.4.4.4.3 Splicing Configuration
The card can be configured to send SCTE 104 messages to encoders of VCMs
fitted in the unit.
The closure (or opening) of the general purpose input pins (GPI Pin 1 – 16) with the
common GND can trigger these SCTE 104 messages. The configuration can be
divided into two parts:
• Setting up the GPI card (pins and messages)
• Setting up the VCMs
5.4.4.4.4 GPI Card Splicing Configuration
When any of the Splice options are selected a further set of configurable options
are available if the GPI Input Pin n Setup is expanded further to show Splicing
Setup
Figure 5.25 GPI Input Pin Splicing Setup
To Next Page
Loading...