Parameter Values Description
AR Signalling Output
Control
Off, AFD Only, AFD and Bar Data
Controls which source is used for embedding aspect ratio
signaling into user data. If set to Off, no aspect ratio data
will be resent in the output. AFD sources are: SMPTE
2016, Video Index, WSS-AFD/WSS, user set Aspect
Ratio. Bar Data is only SMPTE 2016.
TC Output Location Off, SEI Message Defines how timecode is put into the output video stream.
Video Component
The parameters listed in are available on the Component tab of the Properties widget on
the Service Configuration page when a video component is selected in the Outputs
widget. The same parameters can be accessed through the Output/<output
name>/Transport Stream ID: <n>/Service List/<service name>/Component List/Slot
<x> Video Stream on PID <y> menu on the front panel.
Table 5.14 Video Component Parameters
Parameter Values Description
PID 32 to 8190 Sets the packet identifier associated with the component.
Bit Rate Weighting Fixed, Minimum, 2 to 20
Specifies the weight associated to the component in the
Bit Rate Tracking algorithm.
Master TS Off, On Sets the master Transport Stream for the component.
Source PID Monitoring
Off, On
Priority 1 ETR290 monitoring on this PID from an IP input
can be enabled, and can be set to caused a redundancy
switch to a spare device if in a system controlled by
Ericsson control software. Not supported in this release.
Vertical Blanking Interval / Ancillary Data
The parameters listed in the table below are available on the VBI tab of the Properties
widget on the Service Configuration page when a video stream is selected in the Outputs
widget. The same parameters can be accessed through the Advanced/CE-a/Video/Video
1/Input/VBI Extraction menu on the front panel.
Table 5.15 Vertical Blanking Interval / Ancillary Data Parameters
Parameter Values Description
Enable VBI Pass-thru
Mode
Off, On
Enable Pass-thru of VBI, ANC and Teletext data from
specified PIDs, instead of extracting them from SDI. Read
only parameter. Not supported in this release.
Description Control
VBI Descriptor Mode Standard, Legacy, Philips, User
The source for Closed Captions data encoded as part of
the Video Stream (only applicable when Video Frame Rate
is 29.97 Hz)
VBI Data Descriptor
Insertion
Off, On
Controls if the VBI Data Descriptor is inserted into the
PMT. Available only if VBI Descriptor Mode is set to User.
VBI Teletext
Descriptor Insertion
Off, On
Controls if the VBI Teletext Descriptor is inserted into the
PMT. Available only if VBI Descriptor Mode is set to User.
Teletext Descriptor
Insertion
Off, On
Controls if the Teletext Descriptor is inserted into the PMT.
Available only if VBI Descriptor Mode is set to User.
To Next Page
Loading...