Not for commercial use
– Ericsson Inc.
Complete the following steps after you have removed
your terminal and its components from the box:
Attach your belt clip or swivel to your battery
(optional).
Attach the battery to your terminal.
Before using your terminal, fully charge the battery
using the charger provided with your terminal.
Attaching Your Belt Clip or Swivel to Your
Battery
Attach your belt clip or swivel with the screw provided.
Using the belt clip or swivel is optional.
Attaching and Removing Your Battery
Attaching Your Battery
Your terminal comes with a nickel metal hydride
(NiMH) battery. The battery is not charged when you
buy your terminal, but there may be enough power to
turn on the terminal. It is recommended that you charge
the battery before you use the terminal.
Place the battery on the back of the terminal.
Align the tabs on the bottom of the battery with the
slots on the bottom of the terminal.
Attach the battery to your terminal as shown in the
following illustration.
Getting Started
Ditto Lornetta.book Page 14 Thursday, July 13, 2000 3:55 PM
To Next Page
Loading...
