EasyManua.ls Logo

Ericsson R250d PRO - When to Charge Your Battery

Ericsson R250d PRO
75 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Not for commercial use
Ericsson Inc.
 
 Using the other cord supplied, plug the charger into
a standard electrical wall outlet.
When to Charge Your Battery
The NiMH battery that comes with your terminal can
be charged whenever you wish without losing perfor-
mance. This is not the case with the cheaper nickel cad-
mium type batteries, often sold as accessories from other
suppliers. For optimal talk and standby time in the long
run, we recommend that you only use Ericsson original
batteries with your Ericsson terminal.
To remind you that the battery will soon need to be
charged or replaced with a charged one, the following
will occur:
An alarm signal (a long beep) sounds and the mes-
sage Low Battery! appears for 10 seconds in the
display.
The indicator light on top of the terminal starts
blinking red.
Note! When the terminal is left turned on, the low battery
alarm will be repeated several times and, finally, the ter-
minal will turn itself off when the battery is no longer
able to power it satisfactorily. It might be possible to
turn the terminal on again, but you will not be able to
make or receive any calls. You should charge the battery
or replace it with a charged one.
Ditto Lornetta.book Page 18 Thursday, July 13, 2000 3:55 PM

Table of Contents

Related product manuals