Not for commercial use
– Ericsson Inc.
Menu Descriptions 57
Press
Ñ
or
Ô
until the menu pointer is beside
Access No.
Press
.
Enter the calling card access number.
Press
to store the number.
Press
Ô
to move to Ver. no..
Enter the verification number.
Press
to store the number.
Changing the Flow Order
If your long distance service provider requires a different
dialing, you may need to change the Flow Order.
Flow order determines when the numbers are transmit-
ted by your terminal. The default flow is:
• Access number
• Stop
• Number you are calling
• Stop
• Verification number
To c h a n g e t h e f l ow o rd e r :
From the previous Step 12, press
Ô
until the menu
pointer is beside Flow dom. (domestic) or Flow
int. (international).
Press
.
Press
Ô
to scroll through the flow order.
To change a flow setting, press
Ô
until the menu
pointer is beside the setting you want to change.
Press 1 to scroll through the options for that setting.
When you have the flow order you want, press
to store the selection.
Using a Calling Card
To place a call using a calling card:
Enter or recall the number you want to call.
Press and hold
. The calling card number is
shown in the display.
Release the key after the number has been displayed.
If you are using stops between numbers, you must
press
or any number key to send the next
sequence of numbers. If you use pauses, the num-
bers are sent automatically after the specified length
of time chosen in the Flow function.
Terminal Menu
The TERMINAL Menu contains the following sub-
menus for enhancing the use of your terminal for Radio
Setup, Group Setup, and Alert Setup.
Radio Setup
Radio Setup contains the following choices for adjust-
ing the volume levels and answer options while you are
in Radio Mode.
Ditto Lornetta.book Page 57 Thursday, July 13, 2000 3:55 PM
To Next Page
Loading...
