Ericsson R250d PRO - Recalling Numbers; Recalling Previously Dialed Numbers; Recalling a Number Using the Memory Menu

Not for commercial use
– Ericsson Inc.
Storing and Recalling Numbers 39
described steps for entering a name and number, then
press and hold

. The terminal prompts you to enter
your security code. If you enter the correct code, the
number is stored and Stored Securely in Mem-
ory is shown in the display.
Storing a Group Number or Alert Number
A number cannot be stored in Group memory or Alert
memory unless you enter the correct security code. To
store a number, select the appropriate submenu. The ter-
minal prompts you to enter your security code. If you
enter the correct code, the terminal will allow you to
store a number. Follow the same procedure as Storing
Numbers.
Recalling Numbers
Recalling a Number Using the Up Arrow
 Press
Ñ
. The display will look similar to this illus-
tration.
 To recall by name, press the key which represents
the first letters of the name.
OR
To recall by number press
Ô
twice to move the cur-
sor to the RECALL: line and enter the memory
location where the number is stored.
 Press

. The number is displayed after a two-sec-
ond timeout.
Recalling Previously Dialed Numbers
For instructions on how to recall previously dialed num-
bers, see Redialing a Number Using the Up Arrow.
Recalling a Number Using the Memory Menu
 Press
Ô
to access Menu Mode.
 Press
Ô
or
Ñ
until the menu pointer is beside
Memory.
 Press

to open the MEMORY Menu.
 Press
Ô
or
Ñ
until the menu pointer is beside RCL
Mem.
 Press

to open the RCL Mem. display. You can
recall a number in memory by the location number
or by name.
 To recall by name, enter the letters of the name in
the Name: line. You can enter just a few letters of
the name or the complete name. If you enter just a
few letters, the terminal finds the first name in
memory that begins with the letters you entered.
OR
Ditto Lornetta.book Page 39 Thursday, July 13, 2000 3:55 PM