Preparing for Use 11
3. Slide the SIM card into the SIM card holder.
4. Replace the battery.
Note: If you already have a SIM card that contains phone
book entries then this information can be imported to your
R380. See “SIM Card Phone Book Import” on page 20.
To remove the SIM card:
1. Ensure that the R380 is turned off and the flip is closed.
2. Remove the battery.
3. Slide the SIM card out of the SIM card holder.
The battery that comes with your R380 is a lithium ion (Li-Ion)
battery. The battery is not fully charged when you buy your
phone but there may be enough power to turn it on. We
recommend that you charge the battery for three hours before
you use the R380 for the first time.
The first time you charge a new battery, or a battery that has
been completely discharged, it may take a few minutes before
you get any indication that the battery is being charged (the
Status indicator does not light up and the battery meter does not
display).
Note: You cannot turn on the R380 before the Status indicator
lights up and the battery meter displays.
A battery that has not been used for a long period needs to be
completely discharged and then recharged 2-3 times before
reaching full capacity. Should you need to discharge the battery,
simply use your R380 as usual until the battery runs low.
Battery
To Next Page
Loading...
