Preparing for Use 13
Battery Removal and Insertion
To remove the battery:
1. Ensure that the flip is closed and the R380 is off.
2. Push up the release catch at the top of the battery and lift
the battery away from your R380.
To insert the battery:
1. Ensure that the flip is closed.
2. Place the bottom of the battery into position and then push
down on the upper section of the battery until it clicks into
place.
To charge the battery using the charger:
1. Make sure the battery is attached to your R380.
2. Connect the charger to your R380 as follows:
• The flash symbol on the R380 plug must face
upward toward the keyboard.
• Locate the flash symbol by the R380 connector.
• Tilt the R380 plug contacts slightly downward when
inserting into the R380 connector.
➋
➊
➌
To Next Page
Loading...
