Ericsson R380 - R380 Communications Suite Installation

R380 Communications Suite 217
Note: Communication speeds should be set up as follows: serial at
115200 baud.
R380 Communications Suite Installation
Before you can synchronize or back up the contents of your
R380, you need to install the R380 Communications Suite on
your computer.
To install the R380 Communications Suite:
Note: Choose to install without having your R380 connected.
1. Insert the CD into your computer’s CD-ROM drive.
2. Follow the on-screen instructions to install the R380
Communications Suite and/or additional software from
the CD.
Note: The CD starts automatically. However, if it does not,
run the R380 Communications Suite setup file to install
manually.
To run the Setup manually, if needed:
1. Select Run from the Start menu.
2. Do one of the following:
• Enter ‘D:\Start.exe’ where D: is the letter of your CD-
ROM drive or select
Browse and navigate to the
‘Start.exe’ file on the R380 Communications Suite CD-
ROM. Select
OK to start the installation.
or
• Open Windows Explorer and select your CD-ROM
drive. Scroll to, and select, the ‘
Setup.exe’ file.
Preparing your R380
Once you have installed the R380 Communications Suite you
can connect your R380 to your computer. Your R380 has a serial
port for communication.
Note: The modem port deactivates automatically when it has not
made contact with another device for a period of one minute.