ESAB Fabricator 252i User Manual

ESAB FABRICATOR 252i
INTRODUCTION 2-2 Manual 0-5423
2.06 Transportation Methods
WARNING
ELECTRIC SHOCK can kill. DO NOT TOUCH live electrical parts. Disconnect input power conductors
from de-energized supply line before moving the welding power source.
WARNING
FALLING EQUIPMENT can cause serious personal injury and equipment damage.
Lift unit with integrated hand holds at the front and rear of the unit.
Use handcart or similar device of adequate capacity.
If using a fork lift vehicle, place and secure unit on a proper skid before transporting.
2.07 Packaged Items
Fabricator 252i Part No. (W1004401)
- Fabricator 252i Power Supply
- 15 ft ESAB
®
Fusion 250 Amp MIG Gun
- Velocity Contact tips (1 each)
• .030" (0.8 mm)
• .035" (0.9 mm)
• .045" (1.2 mm)
- Victor® Argon Regulator / Gauge & 10 ft. (3M) Hose
-ESAB WeldSkill 200 Amp electrode holder with 13 ft. (4 M) lead
-ESAB WeldSkill 200 Amp ground clamp with 10 ft. (3 M) lead
-Drive Rolls:
• .035" / .045" (0.9 to 1.2 mm) V Grooved Lower & Flat Upper (Fitted)
• .045" (1.2 mm) Flux Cored Roll
- Operating Manual
- 9 ft. (2.75 M) Power cord & NEMA 6-50P 230V AC Plug
Figure 2-2: Packaged Items
A-12953

ESAB Fabricator 252i Specifications

General

Brand	ESAB
Model	Fabricator 252i
Category	Welding System
Language	English