ESAB MXH 300PP - Equipment; 3 Shipment and Packaging

© ESAB AB 2005
- 5 -
bg17e
The wire feed unit provides the Push force and the welding gun's feeding
mechanism the Pull force.
The welding gun can be equipped with a 45° swan neck (accessory), which can be
rotated 360°. The swan neck provides greater accessibility when welding in confined
spaces.
The welding gun is available in 6 and 10 metre lengths with separate conduits for
wire, motor current, welding current and seprate hoses for shielding gas and water.
Each type of welding wire has a unique wire liner (see accessories).
The Push-Pull system is used to obtain the best feeding result e.g. aluminium wire
or in long hoses up to 10 m.
The gun motor gets its voltage from the wire feed unit or the power source.
ESAB's accessories for the product can be found on page 16.
2.1 Equipment
Welding gun MXH 300 PP / MXH 400w PP is supplied with instruction manual, wire
liner (10 m PA-liner black) and fitted feed roller intended for 1.2 mm wire.
3 SHIPMENT AND PACKAGING
The components are carefully checked and packaged, however, damage may occur
during shipping.
Checking procedure on receipt of goods
• Check that the shipment is correct by referring to the shipping note.
In case of damage
• Check the package and components for damage (visual inspection).
In case of complaints
If the package and/or components have been damaged during shipment:
S Contact the last carrier immediately
S Keep the packaging (for possible inspection by the carrier or supplier, or for
returning the goods).
Storage in an enclosed space
Ambient temperature
- for shipment and storage: –25 °C to + 55 °C
Relative air humidity: up to 90 % at a temperature of 20 °C
GB