INSTRUCTION MANUAL
PCM-875
PLASMA ARC CUTTING PACKAGE
F15-335-E
July, 2007
These INSTRUCTIONS are for experienced operators. If you are not fully familiar with the principles of operation and
safe practices for arc welding and cutting equipment, we urge you to read our booklet, "Precautions and Safe
Practices for Arc Welding, Cutting, and Gouging," Form 52-529. Do NOT permit untrained persons to install, operate,
or maintain this equipment. Do NOT attempt to install or operate this equipment until you have read and fully
understand these instructions. If you do not fully understand these instructions, contact your supplier for further
information. Be sure to read the Safety Precautions before installing or operating this equipment.
Be sure this information reaches the operator.
You can get extra copies through your supplier.
This manual provides installation and operation instructions for the following PCM-875 cutting packages starting with Serial No.
PHJ205001:
P/N 36590 - 208/230 V, 1 & 3-Phase, 50/60 Hz
P/N 36592 - 460 V, 3-Phase, 50/60 Hz
P/N 36714 - 575 V, 3-Phase, 60 Hz
P/N 36725 - 400 V, 3-Phase, 50/60 Hz
To Next Page
Need help?
General
