6 CONTROL PANEL
0463 416 001
- 22 -
© ESAB AB 2017
Set parameter
The set indicator (4) will be lit when the displayed value can be changed. It cannot be
changed from the panel when a remote control is activated. Trying to change a value while in
measured value mode will result in automatically move to set current value mode.
The set indicator is off when measured values are shown.
6.1.2 Weld program
For each welding process (MMA/TIG) three different weld programs can be stored in the
setting panel memory (1). Press selection button 1, 2 or 3 for 3 seconds to store a weld
program in the memory. The memory indicator will be lit when finished.
To switch between the different weld programs press button 1, 2 or 3.
To Next Page
Loading...
Need help?
General
