ESAB Robust Feed PRO User Manual

5 OPERATION
0463 691 001
- 30 -
© ESAB AB 2019
1. Attach the torch strain relief to the wire feed unit, using the two Torx5 screws.
2. Attach the wheel kit to the wire feeder using the two screw joints near the rear end of
the wire feeder. Ensure that the two distance washers are inserted between the wheel
kit and the wire feeder.
3. Fasten the wheel kit and the torch strain relief to the wire feeder using the two screw
joints located closer to the front end of the wire feeder.

ESAB Robust Feed PRO Specifications

General

Brand	ESAB
Model	Robust Feed PRO
Category	Wire Feeders
Language	English