Programming Menu
Spec FR
The Spec FR1 meter mode (FR1 = Front and Rear signal strengths of 1 signal) displays the numeric
frequency and band of the highest priority threat along with a front and rear bar graph of its signal
strength. The left bar graph shows the signal in front of the detector while the right bar graph shows
the signal strength from the rear. If there are multiple alerts present, only the signal strength of the
highest priority threat is displayed. Laser is the highest priority threat, followed by Ka, K, then X band
radar. The number in between the bar graphs is the total number of alerts that are being detected.
Expert FR
Expert FR meter mode (FR = Front and Rear signal strengths) simultaneously tracks up to four radar
alerts displaying each alert’s band along with a bar graph of their front and rear signal strengths.
When using this meter mode the rear signal strength bar graph is always the opposite color of the
selected display color. In the above image, a Ka band, two K bands, and an X band signal are being
detected. The X band alert is grey to show that it is a locked out false alert. For more information
about locking out false alerts see the GPS Filtering/TrueLock section. Expert FR meter mode can help
you spot a change in your normal driving environment (e.g., a traffic radar unit being operated in an
area where there are normally other signals present).
Simple
Simple messages replace bands and signal strengths or frequencies:
Caution used when an alert is received while you are traveling below your current Cruise
Alert setting (or posted speed limit for your current location when connected to
Drive Smarter).
Slow Down displayed when an alert is received while you are traveling above the current Cruise
Alert setting (or posted speed limit of your current location, when connected to
DriveSmarter).
16
To Next Page
Loading...
