ESI ES2247B User Manual

Programming the Unit
The Factory Pre-Set Programme
This Channel Programmer has been designed to be simple to use,
requiring minimal user intervenon with a pre-programmed heang
profile.
The pre-set heang mes and temperatures will suit most people
(see table below). To accept the factory pre-set sengs, move the
slider to RUN which will revert the programmer to Run Mode (the
colon (:) in the LCD display will begin to flash).
If the user changes from the factory-set programme and wants to
return to it, pressing the reset buon with a non metallic pointed
tool will return the unit to the factory-set programme. NB. Every
me the reset is pressed, the me and date must be set again (page
10).
5
Pre-Set Temperatures: 5/2 Day
In 7 day seng, the pre-set sengs are the same as 5/2 Day
programme (Mon to Fri and Sat/Sun).
7 Day:
24 Hr:
In 24hr seng, the pre-set sengs are the same as Mon to Fri of
the 5/2 Day programme.
Configuraon
2PU & 2Gr
Configuraon
3PU & 3Gr
Mon - Fri
Times
Sat - Sun
Times
1st ON 1st ON 06:30am 07:30am
1st OFF 1st OFF 08:30am 10:00am
2nd ON 12:00noon 12:00noon
2nd OFF 12:00noon 12:00noon
2nd ON 3rd ON 05:00pm 05:00pm
2nd OFF 3rd OFF 10:30pm 10:30pm

ESI ES2247B Specifications

General

Brand	ESI
Model	ES2247B
Category	Programmer
Language	English