ESI ES2247B - Setting the Programmer Option; Setting the Central Heating Programme

Seng the Programmer Opon (5/2, 7 day, 24hr)
1. Switch the slider to HEATING. Press either the +/- buon to
move between 7 day, 5/2 day or 24hr operaon.
5/2 Day operaon is shown by MO, TU, WE, TH, FR flashing (5
Day) and then SA, SU flashing (2 Day)
7 Day operaon is shown by just one day flashing at a me
24 hr operaon is shown by MO, TU, WE, TH, FR, SA, SU flashing
at the same me.
2. Wait 15 seconds to automacally confirm or press the Home
buon. Move the slider to RUN to return to Run Mode.
Seng the Central Heang Programme
1. Move the slider to HEATING. Choose between 5/2 day, 7 day or
24 hr programmer operaon (see above steps 1-2).
2. Press the Next buon. Press the Day buon unl the
desired day/block of days you want to programme is flashing.
3. The display shows the 1st ON me. Press +/- to set the me (10
minutes increments). Press the Next buon.
4. The display shows the 1st OFF me. Press +/- to set the me (10
minutes increments). Press the Next buon.
5. The display will now show the 2nd ON me. Repeat steps 3-4
unl all remaining ON/OFF periods have been set. On the last OFF
period, press the Day buon unl the next desired day/block of
days you want to programme is flashing.
6. Repeat steps 3-5 unl all days/block of days have been
programmed. Wait 15 seconds to automacally confirm or press
the Home buon. Move the slider to RUN to return to Run Mode.
N.B. The copy buon can be used in the 7 day seng to copy any
chosen day to the next day (e.g Monday to Tuesday or Saturday to
Sunday). Simply change the program for that day, then push copy
repeatedly unl all 7 days (if you so wished) have been changed.
6