What is a Channel Programmer?...
An explanaon for householders
Introducon to the 2 Channel Programmer
This programmer can automacally switch your Central Heang or
Hot Water ON and OFF either 2 or 3 mes a day, at whatever mes
you choose. Timekeeping is maintained through power interrup-
ons by a replaceable internal baery (by Qualified Installer/Electri-
cian only) designed to last for the lifeme of the programmer and
the clock is automacally put forward 1 hour at 1:00am on the last
Sunday of March and back 1 hour at 2:00am on the last Sunday of
October. The clock is factory pre-set to UK me and date, but you
can alter it if you want. During installaon, the installer selects 24
hour, 5/2 day, or 7 day programming and either 2 or 3 on/off
periods per day, via the Technical Sengs (see installaon instruc-
ons).
The large, easy to read display makes programming easy and the
unit is designed to eliminate the possibility of accidental changes to
your programme. Buons normally visible, only affect your set
programme temporarily. All buons which can permanently change
your programme are located behind the flip over facia.
- The 24 hour programmer opon runs the same programme every
day.
- The 5/2 Day programmer opon allows different ON/OFF mes at
weekends.
- The 7 Day programmer opon allows different ON/OFF mes for
each day of the week.
- Pumped System (PU) allows independent control of Central
Heang and Hot Water.
- Gravity System (Gr) does not allow Central Heang without Hot
Water but can provide Hot Water without Central Heang.
IMPORTANT: These sengs should only be changed by a qualified
person. Contact your installer. This programmer is not suitable for
the switching of devices greater than 6Amp rated. (e.g. Not suitable
for use as an immersion mer)
2
To Next Page
Loading...
Need help?
General
