Configure Error Operation-Triggered Alarm
If this function is enabled, alarms are generated if a user
fails the authentication upon three attempts. The
administrator authentication is not allowed within 20
seconds after an alarm is generated.
Configure Tamper Alarm
If this function is enabled, alarms are generated upon
device disassembly.
Configure whether to enable the disassembly alarm.
1. The administrator
password is authenticated.
2. Press 0. (The indicator
turns green and makes a
long beep.)
3. Press 1. (The indicator
turns green and makes a
long beep.)
4. Configure the alarm
setting.
(0: enable; 1: disable)
5. The configuration is
successful. (The indicator
turns green and makes a
long beep.)
6. Exit. (The device
automatically exits the
process when the operation
is completed.)
1. The administrator
password is authenticated.
2. Press 0. (The indicator
turns green and makes a
long beep.)
3. Press 2. (The indicator
turns green and makes a
long beep.)
4. Configure the error
operation-triggered alarm
switch. (0: enable; 1:
disable)
5. The configuration is
successful. (The indicator
turns green and makes a
long beep.)
6. Exit. (The device
automatically exits the
process when the operation
is completed.)
To Next Page
Loading...
