2.5 Configure Door Sensor Mode
The door sensor switch includes three modes:
NONE: The door sensor switch is not used.
NO: The lock is open as long as the door is open.
NC: The lock is closed after the door is closed.
Note: The door sensor mode configured here is used as the basis
for the door sensor alarm.
2.6 Configure Alarm
Note: If an alarm is triggered, the buzzer of the device generates
an alarm. 30 seconds later, the alarm is switched to an alert. The
alarm can be terminated after the user is authenticated.
Configure Alarm Setting
The defaute should be on, when it is set to be close, then
Error Operation-Triggered Alarm, the Alarm delay for the
Door Status Sensor will be disabled.
1. The administrator
password is authenticated.
2. Press 0. (The indicator
turns green and makes a
long beep.)
2. Press 5. (The indicator
turns green and makes a
long beep.)
4. Configure the door
sensor mode. (0: enable; 1:
disable; 2: without door
status sensor).
5. The configuration is
successful. (The indicator
turns green and makes a
long beep.)
6. Exit. (The device
automatically exits the
process when the operation
is completed.)
To Next Page
Loading...
