9
Amplifier - Features
SX-2000D
PHASE SHIFT
Is continously variable
between 0 and 180 degrees.
Special Features
Frontpanel
REMOTE CONTROL
These jack are for use with the enclosed
remote control. Only the low pass signal will be
controlled.
INPUT LEVEL
Accepts line level (RCA) inputs from
0.2 to 9 Volts.
INPUT
This allows you to match the
amplifier input sensitivity to
the output level of the source
(head unit).
PROTECT - LED
It indicates the fault operation of the amplifier.
When the fault conditions (overload, exces-
sive heat or short circuit of speaker) arise, the
protection curcuit is engaged to protect both
the speakers and the amplifier against
damage.
OUTPUT
Provides a full range line level
(RCA) output that allows the
use of additional amplifiers.
POWER - LED
It indicates amplifier has turn
on signal.
LOWPASS
The lowpass filter eliminates the
higher frequencies. The built in
low pass filter is fully variable
from 35Hz to 250Hz, with a rolloff
of 12dB/octave.
SUBSONIC
The Subsonic filter sets the lower
cut-off frequency and protects the
Subwoofer from damage. The
subsonic frequency is fully variable
from 15Hz to 55Hz.
BASS BOOST
Allows you to adjust the bass
boost from 0dB up to 15dB.
Balanced Inputs
Balanced inputs have been used for many years in professional sound studios and high end home
Stereo systems. Unlike the unbalanced RCA's Balanced wires are insusceptible against interferences.
But therefor an signal transmitter with specific wires is required. Ask your specialist dealer for the
required equipment.
To Next Page
Loading...
