Assembly
Assemble the blender and attach it to the blender mount A10 according to Figures 11 a 12.
Instead of the plug for adding liquids F5 you can also insert the pusher F7 in the opening
in the lid if you are going to use it. Apply reverse sequence to disassemble the unit and to
remove it from the mount.
Before the first use
We recommend washing the glass container before using it for the first time. The knife
section is treated with oil not harmful to health for technological reasons. Therefore first fill
in the container with warm water (max. 50 °C) with a small amount of detergent. Then put
the container on the food processor, set the maximum rotational speed and run for
1 minute. Then rinse the container with clear water.
Use
The blender is designed to mix juices, milk cocktails, soups, sauces, children food and
dietetic food, light dough, biscuit dough, puree, etc. Remove the lid, put or pour the food
into the container and replace the lid. To press larger pieces of ingredients to the knife, use
the pusher F7.
Always set the speed with regard to the kind and amount of ingredients being processed,
and particularly with regard to ripeness of fruit and vegetables. We recommend that you
always switch on the blender to minimum revolutions and then gradually increase the
performance as required.
The recommended processing speed is 1 to MAX.
Tips
– When the appliance is in operation, it is only possible to add liquid ingredients
(e.g. water, milk, oil, etc.).
– The longer you process the food in the blender, the finer the mixture is.
– Never use the pusher F7 individually without the lid F1.
– If you are going to process larger amount of food, divide it into batches not to overload
the motor unit of the multifunctional head.
– Cut tougher substances into small pieces, otherwise the knife F3 will soon become blunt.
– If you are going to mix ice cubes, their size should not exceed 40x40x20 mm, otherwise
the knife F3 becomes blunt or the motor unit is overloaded.
– Never fill the container with liquids producing foam (for example milk) up to „MAX“ level
to prevent overspill. We recommend 1 litre at maximum.
– If you are not satisfied with the result, switch off the appliance, mix the ingredients with
the wiper, remove part of volume or add a little more liquid.
– Soak hard food (such as legumes, soybeans, etc.) in water before further processing.
– If you prepare a small amount of ingredients for beverages, doughs or purees, it is
recommended to pour a small amount of liquid in the container before you start mixing.
III.7) Pasta maker (G1 - G3)
Description (Fig. 13)
G1 – Pasta rolling attachment (for lasagne, raviolli, cannelloni)
G2 – Wide noodles cutter (tagliatelle) 7 mm
G3 – Narrow noodles cutter (trenette); 1.5 mm
85
GB
To Next Page
Loading...