27 / 36
Connection to your alarm system
The detectors in your kit are already connected and ready to use. If you have deleted the
detector from the control panel, you can reconnect it as follows:
1.Press once on the Connection button located on the control panel.
2.Press the Test button at the back of the detector. The control panel will beep once
acknowledging the connection. If the control panel beeps twice, the detector was
already connected.
Specifications
Power supply: DC 3V (AA 1.5V LR6 Batteries x 2)
Static current: ≤ 30 uA
Alarm current: ≤ 15 mA
Detection scope: 8 m / 110°
Transmission distance: ≤ 80 m (in open area)
Radio-frequency: 433.92 MHz (±75KHz)
Housing material: ABS plastic
Operating conditions: Temparature: -10°C~55°C Relative humidity: ≤ 80%
(noncondensing)
Dimensions (L x W x H): Detector: 107 x 53 x 32 mm, Bracket: 52 x 30 x 26.5 mm
To Next Page
Loading...
