EN 20
Cleaning the appliance
Clean your appliance regularly to prevent a build-up of grease and food particles, especially on
interior and exterior surfaces, the door and door gasket.
• Clean the exterior surfaces with a soft cloth and soapy warm water.
• Wipe afterwards with a clean, damp cloth and dry the surfaces.
• Remove splashes and stains on the interior surfaces with a soapy cloth.
• Wipe afterwards with a clean, damp cloth and dry the surfaces.
Take care that no water enters the vents. Never use abrasive cleaning agents or
chemical solvents. Ensure that the door gasket is always clean. This will prevent a
build-up of dirt so that the door can close properly.
Removing and cleaning the guide rails
1. Remove all accessories.
2. Completely loosen the nut at the front of the fastening element (A).
3. Pull the guide rails forward (B) and remove them.
4. Use conventional cleaning products to clean the guide rails.
5. Assembling the guide rails; insert the rear notch into the rear fastening nut (C).
6. Fix the front fastening nut in the front notch of the support (D).
7. Turn the support until it is fully adjusted (E) and secure the support with the nut (F).
A F
B
E
E
B
C
D
MAINTENANCE
To Next Page
Loading...
