2 | 26
Etrel Inch | User Manual
|
1 SAFETY INFORMATION
Etrel INCH charging station has been designed and tested in
accordance with up-to-date international standards. The charging
station is compliant with IEC 61851-1 international standard
which defines conductive AC electric vehicle charging (Part 1, Part
21 and Part 23) and supports Mode 3 charging for safe recharging
of any standard electric vehicle.
Use the charging station exclusively for the purpose intended.
Preparation of charging station installation site and installation of
Etrel INCH are described in separate documents. In this document
it is predisposed that charging station is installed properly and
working.
INTENDED USE
Etrel INCH charging station is intended only for charging of
electric vehicles and should not be used to charge any other
appliances or devices or for any other purposes. The manufacturer
accepts no responsibility for damage or injuries resulting from
incorrect installation or inappropriate use of the product.
Maintenance
Charging station can be maintained and repaired by qualified
personnel only.
Charging station’s power supply should always be switched
off during the maintenance and repair.
Avoid hazardous risks. Only the manufacturer, an authorized
service technician, or technically qualified personnel may
replace damaged charging station or its components.
Operation
Do not operate your charging station if there is visible
damage to the unit or charging cable. Call manufacturer’s or
reseller’s support department for advice how to proceed.
Do not put fingers into the charging connector.
Do not operate the charging station with wet hands.
The charging station manufacturer cannot be made liable for
damage or injury caused by improper handling, installation, or
use of the product.
Any usage of the product not covered in this document is not
allowed and could cause injury or death.
To Next Page
Loading...
