26 | 26
Etrel Inch | User Manual
|
the fid was tripped but you can’t move the switch back into active
position. To change the RCD please call the support number.
Figure 37: RCD test button
Overcurrent protection
Check the overcurrent protection (if installed) once a year for any
visible damages on the surface. If the overcurrent protection is
tripped and the switches can’t return to the active position
something is wrong with the protection and needs to be changed by
maintenance crew.
USING WEB INTERFACE FOR
TROUBLESHOOTING
You can also use web interface for trouble shooting like it is
described in the diagnostics section of chapter 4 Web interface.
For more extensive troubleshooting you should read the
Troubleshooting document for users named: Etrel INCH
Troubleshooting user.
To Previous Page
Loading...
