Etrel INCH - FIRST CHARGING SESSION; Charging Modes Explained

8 | 26
Etrel Inch | User Manual
|
Green light is
blinking
LCD is turned on
and charging
station is ready
to be used.
When the LCD
starts the logo
will be first
displayed and
after that you can
start using the
charging station.
LCD is turned on
but freezes and is
unresponsive.
Try resetting the
charging station. If
the problem
repeats there
might be a
problem with the
software. You
should call the
support.
You can read the
resetting
procedure in
chapter 6
Troubleshooting.
YOUR FIRST CHARGING SESSION
When the charging station is ready to be used you can simply follow
the procedures described on the Etrel INCH’s LCD screen. You can
choose between two charging modes:
 Fast charging (default)
 Interactive charging
Charging modes are chosen during the charging session.
During the fast charging your EV will be charged with the max
available charging power as fast as possible. Max power is set by the
installer based on the grid capabilities where charging station is
installed.
When Interactive charging is chosen charging schedule will be
modified based on the inserted departure time or if it is not inserted
based on historic session data. Historic data is used from the first
charging session onward. More charging session means more
accurate session prognosis and schedules. Charging schedule will be
created based on electricity prices, other loads and PV production to
make sure EV is charged in appropriate time while taking in
consideration other constraints.
Charging procedure
Step1: WAKE
When you come to the charging station its LCD screen will likely be
in the screen saver mode. You can wake it up by simply tapping the
screen.