Etrel INCH - OPERATION AND CHARGING PROCEDURE; First Charging Station Power Up

7 | 26
Etrel Inch | User Manual
|
4 OPERATION OF CHARGING STATION AND
CHARGING PROCEDURE
FIRST CHARGING STATION POWER UP
When you power up the charging station for the first time it can take
several minutes for station to get ready to start using it to charge EV.
Charging station is powered up automatically when it is connected
to the electricity. In the table below, you can see all the possible
events that can occur when you start the station and what should
you do in case something is wrong.
STATUS LIGHT
NORMAL
OPERATION
PROBLEM
SOLUTION
Fast blinking
green light
Charging
station’s backup
batteries are
charging. At the
first power, up it
can take up to 10
min. If backup
battery is full
green light will
blink slowly.
If the light is
blinking fast
more than 10
min there might
be a problem
with the backup
battery.
Inform the support
about the status of
your charging
station.
Slowly blinking
green light
LCD screen is
preparing to turn
on. Heating
system is trying
to heat the LCD
before it is
turned ON.
If the green light
is blinking slowly
for more than 10
minutes and the
LCD hasn’t been
turned on, there
might be a
problem with the
LCD.
You should call
the support.
Steady glowing
green light
Charging station
is ready to be
used.
/
/
No lights
/
If charging
station is not
responding after
it is powered up,
something might
be wrong with
connection.
Check the
protection
elements if either
RCD or
overcurrent
protection has
been tripped.
Activate the
protection. If
nothing helps call
the support or
installer.