To Next Page

To Previous Page

GB Bicycle rack CROW BASIC for trailer tow bar

Item number 11569

Content

1. Proper use of the product 8

2. Scope of delivery 8

3. Specications 8

3.1 Coupling requirements 9

4. Safety precautions 9

5. Operating instructions 10

5.1 Completing the bicycle rack 10

5.1.1 Mounting the U-shaped bracket 10

5.1.2 Mounting the license plate holder 10

5.2 Dismantling the bicycle rack 11

5.3 Mounting the bicycle rack on the trailer tow bar 11

5.4 Mounting the short tensioning straps 11

5.5 Mounting the bicycles to the rear rack 12

5.6 Folding up the bicycle rack 12

6. Maintenance and care 12

7. Notes regarding environmental protection 12

8. Contact information 12

WARNING

Please read the operating instructions carefully prior to use and observe all safety instructions!

Not observing such may lead to personal injury, damage to the device or to your property!

Store the original packaging, the receipt and these instructions so that they may be consulted at a later date! When passing on the product,

please include these operating instructions as well.

Please check the contents of package for integrity and completeness prior to use!

1. Proper use of the product

This bicycle rack is mounted to the trailer tow bar of a car and is designed for the transportation of two bicycles.

This device is not designed to be used by children or persons with limited mental abilities or without experience and/or lack of required specialist knowledge.

Keep children away from the device.

The device is not designated for commercial use.

Use according to the intended purpose also includes the observance of all information in these operating instructions, particularly the observance of the safety

notes. Any other utilisation is considered to be contrary to the intended purpose and may lead to material damage or personal injuries. EAL GmbH assumes no

liability for damage resulting from improper use.

2. Lieferumfang

1 x Bicycle rack, assembled

1 x U-shaped bracket with two frame holders

2 x Knob nut M8

2 x Lock screw M8 x 60

1 x Safety strap

1 x Installation wrench

1 x Operating instructions

2 x Washer M8

1 x License plate holder

1 x Hexagonal screw M16 x 1.5 x 90