EUFY RoboVac 11c+ - Wi-Fi Setup and Reset; Voice Control Setup

Wi-Fi Status Light
Slowly flashing blue
Waiting for connection
Rapidly flashing blue
Connecting with your wireless
router
Solid blue
Connected with your wireless
router
● If you have any problem with Wi-Fi setup, refer to the “Troubleshooting > Wi-Fi
connection” section in this manual.
● If RoboVac gets stuck in any space, tap Find My Robot in the app to find the machine.
This function is available in the app only.
Reset the Wi-Fi Connection
Press and hold on RoboVac for 10 seconds to reset the Wi-Fi connection if
necessary.
- You will hear a beep when the Wi-Fi connection has been reset and the Wi-Fi
status light will slowly flash blue. Now you can follow the Wi-Fi instructions in the
EufyHome app to set up the Wi-Fi connection.
Use Your RoboVac with Amazon Alexa / the Google Assistant
(Optional)
Amazon Alexa or Google Assistant is a smart voice control device that enables you to control
RoboVac with your voice.
Before you start, make sure that:
● RoboVac is attached to the charging base to ensure there is enough power.
● RoboVac is connected with the EufyHome app.
● You have an Alexa-enabled device (i.e. Eufy Genie, Amazon Echo, Echo Dot and
Amazon Tap) or a device enabled with the Google Assistant (i.e. Google Home). These
devices are sold separately.
● The Amazon Alexa app or Google Home app is already installed on your smart device,
and you have created an account.
To control RoboVac with Amazon Alexa: