FILLING THE DETERGENT SOLUTION TANK
The tank should be filled using clean water mixed with an appropriate detergent solution suited for the type of floor and
for the dirty conditions of the floor and using a product suitable for cutting down foam.
Use the mouth of the tank (see position 3) to fill the solution tank.
For TRAC and ECO versions, there is a filter (see position 2) located inside the mouth of the tank (see position 3), which
should only be removed if the opening is clogged or obstructed.
Use either a rubber hose (see position 1) connected to the water distribution system or a clean bucket (see position 3) and
pour water into the tank.
Make sure the water used to fill the tank does not exceed 40°C.
Look at the instructions on the package to determine how much detergent solution to use, how to mix the solution and
what safety precautions to take before using the product.
Make sure to use low-foaming liquid detergents or appropriate products to cut-down foam.
Fill up the tank only to the level indicated by the filter (see position 2) without exceeding notch 1 (see position 5), which
is located in the rear part.
The tank level can be viewed through the clear pipe (see position 6).
In order for the machine to work properly, it is advisable not to exceed notch 1.
WARNING: DO NOT POUR INFLAMMABLE LIQUIDS INTO THE TANK.
To Next Page
Loading...
