Eureka E51M - Adjusting the Detergent Solution on the Brushes; Using the Machine; Check before Use

22
ADJUSTING THE QUANTITY OF SOLUTION
ON THE BRUSHES (WATER + DETERGENT)
The quantity of the solution on the brushes can be adjusted using
the lever in position 1.
The lever in upward position will shut-off the flow of the solution
completely.
Push down the lever gradually so the valve can open and increase
the flow of the solution progressively.
Adjust the flow according to the operating speed and the dirty
conditions of the floor.
Is fitted with a solenoid valve that keeps the solution from spilling
out when the machine comes into a stop position.
USING THE MACHINE
Our squeegee machines must be operated by properly trained authorised staff.
Squeegee machines that do not operate properly must be taken out of service immediately.
CHECK BEFORE USE
Make sure to check the following before using the machine:
 Make sure the battery connector is plugged-in;
 Make sure the key is fitted correctly;
 Check the battery charge level.
The level of charge in the batteries is displayed via the
battery level indicator. When the brush is activated the
machine runs a check of the batteries, and the LEDs on the
indicator light up. During this phase the brush completes
one rotation and then stops. After a moment, the brush
restarts working and the battery level indicator will reflect
the level of charge in the batteries. If the red LED is on the
brushes will stop working automatically, therefore connect
the charger and fully charge the batteries.
 Make sure the brushes or discs are in good condition
and mounted correctly.
 Make sure the splash guards that are mounted into the
brush plate are in good condition.
 Make sure the rubber wheels on the squeegee are in
good condition and set properly.