EUROMAG | MC608 | Ed. 10/2018
MC608 INTRODUCTION 1
1 INTRODUCTION
IMPORTANT WARNING! It is very important that all personnel working with the equipment have
read and understood the instructions and indications provided in this manual, and that they
follow them prior to using the equipment itself. The manufacturer assumes no responsibility for
the consequences resulting from improper use by the worker.
The suitability of the device for particular purposes shall be worker’s responsibility.
The warranty will be considered void in case of improper installation and use of devices (systems).
• The manufacturer shall bear no responsibility for any damage caused by improper use, improper
installation or tampering of own products. Installation, connection, commissioning and maintenance
must be carried out by personnel who are qualied and authorized for this purpose. The personnel
in charge of the installation must make sure that the measurement system is properly connected as
per the wiring diagram indicated in this document.
• The manufacturer shall bear no responsibility for any damages or injuries resulting from any
misunderstanding of this manual. In order to avoid possible accidents to persons or things caused
by incorrect interpretation of the instructions, the user must not proceed with operations and/or
interventions on the converter if there are uncertainties or doubts regarding the operation(s) to be
performed. We recommend contacting Assistance Service for clarications in this regard for more
precise instructions.
• The manufacturer will be held responsible only if the converter will be used in its original conguration.
For applications that require high working pressures or use of substances that may be dangerous
for people, the environment, equipment or anything else: In case of pipe breakage, EUROMAG
INTERNATIONAL recommends to take the necessary precautions such as adequate positioning,
protection or installation of a guard or safety valve, before installing the CONVERTER in the COMPACT
version.
The device contains live electrical components, therefore installation, checks and maintenance must be
carried out by experienced and qualied personnel who are aware of all necessary precautions to be
taken. Before opening any internal part, please disconnect the power supply.
1.1 MANUFACTURER’S STATEMENT
» Stresses and loads possibly caused by earthquakes, strong winds, re damage, vibrations and
natural disasters were not taken into account in the phase of machine designing.
» Do not install the machine in such a way that it acts as a focus for stresses on the pipes. External
loads were not taken into account in the device conguration.
» While the device is working, the pressure, supply voltage and/or temperature values indicated on
the label or in this Operating Manual must not be exceeded.
1.2 PACKAGING VERIFICATION
At the moment of purchase and/or upon receipt of the product, the buyer is strongly advised to check the
quality of the packaging which must be intact, without visible dents and completely and correctly closed.
When opening the packaging, also check that the product complies with the information on the packing
list in terms of completeness of components/accessories.
NOTE: All EUROMAG INTERNATIONAL software packages are available on the USB ash drive
key that accompanies the product.
The software can also be downloaded from the website www.euromag.com by accessing the
Download Area. A free registration will be required after which you can download the conguration
software for your product.
To Next Page
Loading...
Need help?
General
