Evco c-pro 3 micro User Manual

EVCO S.p.A. c-pro 3 micro and c-pro 3 kilo | Hardware manual ver. 1.0 | Code 114CP3UKE104
page 32 of 62
6.4. List of configuration parameters
Submenu Parameter Min. Max. Unit Preset Description
Info PROJ parameter available in read only modality
information about the application project
(project, version and revision)
Info FW parameter available in read only modality
information about the firmware (project,
version, revision and subrevision)
Info HW parameter available in read only modality
information about the hardware (version,
revision, generic (G) or special (S))
Info SW parameter available in read only modality
information about UNI-PRO 3 (version and
revision)
Info SN parameter available in read only modality
information about the serial number and the
result of the productive test
Info MASK parameter available in read only modality
information about the mask (it depends on
the builder’s coding system)
Info date and time parameter available in read only modality
date and time of the last compilation of the
application project
Parameters (1) AI1 - - - - - - - - - NTC
kind of probe analog input 1
PTC = PTC probe
NTC = NTC probe
0-20mA = 0-20 mA transducer
4-20mA = 4-20 mA transducer
0-5V = 0-5 V ratiometric transducer
0-10V = 0-10 V ratiometric transducer
PT1000 = Pt 1000 probe
NTCK2 = NTC probe type 2
NTCK3 = NTC probe type 3
RESIST = reading of the electric
resistance

Evco c-pro 3 micro Specifications

General

Brand	Evco
Model	c-pro 3 micro
Category	Controller
Language	English