Evector EV-97 EUROSTAR SL MICROLIGHT - Periodic Maintenance and Inspections

EV-97 Eurostar SL Microlight Maintenance Manual GEN/EUR/04 Issue 4 25
11.
COCKPIT
11.1
Instrument panel
11.1.1
Visually check condition and attachment of the
instrument panel
 
11.1.2
Check condition and attachment of individual
instruments
 
11.1.3
Check function of instruments



11.1.4
Check throttle and choke controls for free
movement. Check throttle friction nut.
  
11.1.5
Inspect completeness and readability of
placards
 
11.1.6
Check parachute release, safety lock secure,
placard legible.



11.2
Seats
11.2.1
Visually check seat upholstery, remove
upholstery

11.2.2
Visually check seats and backrests‘ condition

11.2.3
Check for loose rivets or any other damage on
the seats

11.2.4
Visually check main landing gear leg
attachments inside the fuselage

11.3
Safety harness
11.3.1
Visually check condition, attachment, security
and operation of buckles

11.4
Hand control
11.4.1
Check hand control for free movement



11.4.2
Check all joints and bearings for wear and
security.
  
11.4.3
Check control column stops for condition

11.4.4
Check pitot static hoses for water at lowest
point of water collection loop (behind port
cockpit side upholstery panel). Drain any
water by disconnecting one end of drain loop.
Reconnect after draining.
 
11.4.5
Lubricate per Lubricating Chart



11.5
Rudder control
11.5.1
Check for free movement.



11.5.2
Check cable tension.

11.5.3
Check cable stops for condition and security.

11.5.4
Check condition and security of cables and
end fittings.
  
11.5.5
Check operation and security of adjustable
rudder mechanism, 4 pedals.
  
11.5.6
Lubricate per Lubricating Chart



11.6
Flap and trim controls.
11.6.1
Remove cover



11.6.2
Check free movement of levers



11.6.3
Check operation of flap control lever lock
(push button)
 
11.6.4
Lubricate per Lubricating Chart



11.6.5
Replace Cover



11.6.6
Check trim lever friction force. Force to move
lever should be min 1.0 kg at lever end.
Adjust friction if necessary.

