EasyManuals Logo

Evenflo Chase User Manual

Evenflo Chase
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
18 19
NOTE: Refer to your vehicle owner’s manual for
the location of the anchor bracket in your vehicle.
Older vehicles may not come equipped with anchor
bracket hardware. Check with your vehicle dealer.
If you have questions regarding tether anchors which
are not addressed by the vehicle owner’s manual, or
answered by an authorized dealer/vehicle manufac-
turer, call Evenflo’s ParentLink at 1-937-773-3971.
Attach tether hook to anchor bracket . Pull loose
end of the top tether strap to tighten and remove all
slack.
To avoid a strangulation hazard, you MUST tightly roll
or fold excess tether strap and secure with the rubber
band.
Attach the tether hook to the storage clip when not in
use. This will keep an unused tether from hitting some-
one during a crash.
4
After adjusting the top tether strap, you may have
excess strap. Because you may wish to install the child
restraint in more than one vehicle DO NOT cut off the
excess length. If you do, you may not have enough
length to use the top tether strap in another vehicle.
Tightly roll up the excess tether strap and place the
rubber band around the bundle.
DO NOT use this child restraint if it moves more than
25 mm (1 inch) forward or side-to-side at the belt
path. Serious injury or death may result from poor in-
stallation. Move the child restraint to another seating
location, or try to tighten the seat belt again.
DO NOT allow the vehicle seat belt release button to
touch the child restraint. Accidental contact may cause
the seat belt to release. If necessary, turn the vehicle
seat belt release button away from the child restraint
or move the child restraint to a different location.
3
Using your full weight, push the child restraint firmly
into the vehicle seat, while pulling up on the strap to
tighten.
Make sure the belts are tight. If you can move the child
restraint more than 25 mm (1 inch) forward or side-to-
side at the belt path , the belts are not tight enough.
You will need to try again, or find another location for
your child restraint.
Using the Child Restraint With the 5-point Harness: 9 – 21.3 kg (20 – 47 lbs) LATCH Installation
WARNING
WARNING

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Evenflo Chase and is the answer not in the manual?

Evenflo Chase Specifications

General IconGeneral
BrandEvenflo
ModelChase
CategoryCar Seat
LanguageEnglish

Related product manuals