The seat belt must be as tight as possible. Using your
knee, put your full weight into the seat as you tighten
the seat belt.
To keep the seat belt
tight, you may need
to use a locking clip
with some lap/shoulder
belt combinations. See
instructions under
“Using the Locking Clip”
and consult your vehicle
owner’s manual.
DO NOT use this child restraint if it moves more than
25 mm (1 in.) forward or side-to-side at the belt
path. Serious injury or death may result from poor
installation. Move the child restraint to another
seating location, or try to tighten the seat belt again.
2
3
12 13
Using the Child Restraint with the 5-point Harness: 9 – 21.3 kg (20 – 47 lbs) Seat Belt Installation
Attach tether hook to anchor bracket . Pull loose
end of the top tether strap to tighten and remove all
slack.
• To avoid a strangulation hazard, you MUST tightly
roll or fold excess tether strap and secure with the
rubber band.
• Attach the tether hook to the storage clip when not
in use. This will keep an unused tether from hitting
someone during a crash.
4
After adjusting the top tether strap, you may have
excess strap. Because you may wish to install the
child restraint in more than one vehicle DO NOT cut
off the excess length. If you do, you may not have
enough length to use the top tether strap in another
vehicle. Tightly roll up the excess tether strap and
place the rubber band around the bundle.
NOTE: Refer to your vehicle owner’s manual for
the location of the anchor bracket in your vehicle.
Older vehicles may not come equipped with anchor
bracket hardware. Check with your vehicle dealer.
If you have questions regarding tether anchors which
are not addressed by the vehicle owner’s manual, or
answered by an authorized dealer/vehicle manufac-
turer, call Evenflo’s ParentLink at 1-937-773-3971.
➚
WARNING
WARNING
To Next Page
Loading...
Need help?
General