Using the Belt-positioning Booster
Place the belt-positioning booster cushion on the
vehicle seat. Put child in the belt-positioning booster
cushion so that the child’s back and bottom are flat
against the booster cushion. Place the vehicle’s lap/
shoulder belt across the child and buckle the seat belt.
This belt-positioning booster cushion has two
positioners through which the shoulder belt can be
adjusted to correctly fit the child.
The vehicle’s lap belt should be low and snug across
the child’s hips.The vehicle’s shoulder belt must cross
the child between the child’s shoulder and neck.
1
Place a towel
under the seat to
protect the vehicle
upholstery.
You MUST route the vehicle’s lap
belt between the back of the
armrest and seat. (Armrests are
not available on all models.)
Using the Child Restraint as a Belt-positioning Booster Cushion 18 – 45.3 kg (40 – 100 lbs)
28 29
TIP!
TIP!
The shoulder belt should NOT cross the child’s neck
or fall off the child’s shoulder. NOTE: If the vehicle’s
shoulder belt naturally crosses the child’s shoulder,
you do not need to use the shoulder belt positioners.
This child restraint system, even when unoccupied, MUST
be firmly secured with a vehicle seat belt/LATCH harness
and tether strap at all times. An unsecured child restraint
may injure someone if a crash occurs.
Checklist for a Properly Secured Child
Child’s ears
MUST
be below the top of
the child restraint.
Vehicle shoulder
belt must fall
between the
child’s neck
and shoulder.
Child’s back
and bottom
rest flat against
the seat.
Vehicle lap belt
should be low and
snug across the
child’s hips.
When using the child restraint as
a belt-positioning booster cushion
with the vehicle lap/shoulder belts,
you MUST route the lap portion of
the seat belt between the back of
the armrest and seat.
WARNING
To Next Page
Loading...
Need help?
General