16 17
LATCH is a system for attaching the child restraint to your
vehicle seat. It is to be used in place of your vehicle’s seat
belts, and can only be used in vehicles with LATCH
anchors. Your vehicle owners manual may refer to this
system as ISOFIX.
• This LATCH system is intended to be used ONLY as
described in these instructions. Serious injury or death
may result from misuse.
• In addition to these instructions, read and follow your
vehicle owner’s manual regarding installation of the
child restraint and LATCH. If there is a discrepancy, fol-
low your vehicle owner’s manual.
• ONLY use for securing convenience base to lower LATCH
anchor points.
• NEVER attach two LATCH connectors to one vehicle
lower anchor point.
• NEVER use the vehicle seat belts when using the LATCH
system. Using both together can cause slack in a sudden
stop or crash.
• When not in use, the LATCH connectors should be
securely stored in the storage area located in the
convenience base (see page 40). Keep out of reach
of children.
•
ALWAYS be sure that the LATCH connectors are fully
engaged onto the LATCH anchor points by pulling hard
on the LATCH harness. If they are not totally engaged,
the LATCH system will not secure your child restraint.
Serious injury or death may result.
• DO NOT use this child restraint if it moves more than
1 inch (25 mm) forward or side-to-side at the vehicle
belt path. Serious injury or death may result from poor
installation. If you can not tightly secure the child
restraint, try again or move it to another location.
• This child restraint
MUST face the rear of the vehicle.
WARNING
Installing the Convenience Base with
the LATCH System
Place the base A on
the vehicle seat.
Route the LATCH harness
and hook through the
LATCH harness openings
and under the tabs
B.
Refer to your owner’s manual to
locate the lower anchors on your vehicle seat.
Attach the right hook C to the right anchor D, and
the left hook to the left anchor. DOUBLE CHECK that
the hooks are fully engaged by pulling hard on the
LATCH harness.
B
2
Using your full weight, push the base firmly into the
vehicle seat, while pulling up on the strap E to tighten.
Make sure the LATCH harness is tight.
If you can move the child restraint more than 1 inch
(25 mm) forward or side-to-side at the harness path F,
the harness is not tight enough. You will need to try
again, or find another location for your child restraint.
DO NOT use this child restraint if it moves more than
1inch (25 mm) forward or side-to-side at the seat belt
path. Serious injury or death may occur. Move the
child restraint to another seating location, or try to
tighten the seat belt again.
WARNING
E
F
A
1
D
C
To Next Page
Loading...
